With Rotate Angle 0º- 90 º And 243Kw Engine Power Modified
Multifunction Drill Rig
The TDR-50 is mounted on the undercarriage of excavator with a
total weight of 35 ton. The engine power 243 Kw.
Constructed of high tensile steel and hydraulically elevated, mast
lifting and lowering and degree of slope controlled by four (4)
double acting hydraulic cylinders. The mast is equipped with 4
guide rails for the carrier of the drill head and a suspension for
the feed device. The rig is also equipped with slipper system, in
order to the mast slip, and the stroke is 3.65m, the mast can be
reliably based on the ground. The rig can be set up the blowout
preventer and other systems.
Mud Line System
All mud lines on the TDR-50 Drilling Rig have 3″ (76.2mm) diameter,
in order to reduce friction losses to a minimum.
Top Drive head
Top drive head suits for tricone bit, DTH hammer, PDC Drill bit and
diamond bit which meets special demand of rotate speed and torque
during work. The 4-shift Gearbox using spur gear drive, oil bath
lubrication. Hydraulic Motor and gearbox could provide for much
high speed and torque to be adjusted.
The angle of rotate unit could be adjusted as needed, ranges from
The water connector can hold a pressure maximum 35Mpa.
Generator and battery are driven by diesel engine and provide 24V
direct-current power supply. All cables are protected with seal
line. Furthermore, all circuits are equipped with short-circuited
Additional Rig Components
TDR-50 Rig can be modified. All kinds of aggregates, required for
different drilling methods, can be installed on the rig at customer
request, or supplied as stand-by aggregates.
● Rotary-drilling with direct circulation
● Rotary-drill with reverse circulation
● Auger drilling
● Percussion core drilling(ram coring)
● Wire line core drilling
● Down-The-Hole hammer DC and RC drilling
Drilling Depth Guidelines
|Use 5″rod||600 – 1 000 m|
|Use 4-1/2 ″rod||800 – 1 300 m|
|Use 3-1/2″rod||1 000 – 1 500 m|